Step 1:
Attach the handle to the jig using the two M5x12mm screws provided
Attach the handle to the jig using the two M5x12mm screws provided
Step 2:
*IMPORTANT* - For the Lamello Zeta P2 only
*IMPORTANT* - For the Lamello Zeta P2 only
- Set the P-System function to the off position
- For 4mm grooves use a biscuit blade and for 7mm grooves use the normal blade
Step 3:
Attach the jig to the tool using the screws provided
Attach the jig to the tool using the screws provided
- Festool Domino use the M5 x 16mm screws
- Lamello Zeta use the M5 x 10mm screws
|
|
Step 4:
- Set the cut depths on your tool
- Mark your cut position on the material
- Both Lamello and Festool are 10mm from the base to the centre of the cutter
- Mark your line 10mm from where you want the centre of the cut to be, then align the indent on the jig to that line.
Safety Information:
- PPE is always recommended e.g. safety googles and hearing protection.