1) From the front edge of the cabinet, drill a pilot hole using the below measurements.
Door Width + 7mm* = Pilot Hole location e.g. 18mm door + 7mm = 25mm
*7mm gives you 2mm of adjustment
2) Screw the door stop in place with the provided screw, do not fully tighten.
4) Adjust the door stop so the door sits fits flush with the cabinet frame.
5) Tighten the screw so the door stop is held firmly in place and doesn't move.
Door Width + 7mm* = Pilot Hole location e.g. 18mm door + 7mm = 25mm
*7mm gives you 2mm of adjustment
2) Screw the door stop in place with the provided screw, do not fully tighten.
4) Adjust the door stop so the door sits fits flush with the cabinet frame.
5) Tighten the screw so the door stop is held firmly in place and doesn't move.